57
EXTRAORDINARY MAINTENANCE
5.
Lift the handle (2) to access the motor compartment
6.
Turn the seat mounting plate as far as it will go
7.
Use a suitable tool to disconnect the battery from the machine system
WARNING: The first cable to be disconnected is the “+” pole, followed by the
“-“ pole.
8.
Remove the battery clamp (3)
9.
Use suitable means to lift the battery out of the machine
10.
Use suitable means to insert the new battery in the machine, positioning it as shown in the figure
11.
Use a suitable tool to connect the battery to the machine system
WARNING: The first cable to be disconnected is the “+” pole, followed by the
“-“ pole.
12.
Fix the battery to its support with the aid of the clamp (3)
68.
WASHING THE DOSING SYSTEM (VERSIONS WITH CDS)
The dosing system should be cleaned when the machine is not used for a long period (more than 48
hours); to do so, proceed as follows:
1.
Make sure the squeegee unit is in its idle (raised) position (if necessary, turn the I-DRIVE selector to
the “Transfer” position to raise both the brush head and the squeegee)
2.
Make sure the electrical system connector (1) is disconnected from the battery connector (2); if
necessary, disconnect it
3.
Make sure the main switch (3) is in the "0" position. If it is not, turn the key a quarter turn to the left
4.
Check the parking brake is engaged. If it is not, engage it by means of the lever (4). Make sure the
electrical system connector is disconnected from the battery connector
-
+
3
-
+
3
4
3
