31
WORK
As the batteries run out, the battery charge indicators on the display will go blank; when the batteries are
fully discharged the brush motor automatically turns off, it is therefore necessary to recharge them as soon
as possible.
A residual charge remains available to complete the drying process and to move the machine to the
charging point; to do this, choose the "Transfer" programme.
When the level of solution (for versions without CDS) or water (for versions with CDS) is about to run out,
the red warning light (16) on the instrument panel will come on; when the solution or water is completely
used up, take the machine to the place designated for emptying the recovery tank. On completion of the
emptying operation, refill the solution tank.
When the brush motor overload limit is exceeded, the red warning light (17) on the instrument panel
begins to flash. After a few seconds the motor stops and the indicator light of the brush switch goes off.
To start up the motor again, turn the main switch key (3) off and on again. If the motor stops again, check
the reason of the overload in order to prevent damage to the motor. Check to see if the knob (8) to
increase the pressure on the brushes has been operated and, if so, turn it anticlockwise as far as it will go.
When the warning light (18) on the instrument panel lights up during machine operation, it means that the
brake oil level is low (down to reserve); top up as soon as possible.
33. MOVEMENT OF THE BRUSH HEAD UNIT
This machine is able to move the brush head unit towards the right-hand side of the machine; simply
move the knob (1) on the instrument panel to the right, to move the brush head back move the knob (1) to
the left.
16
17
3
8
18
1