USER
MANUAL
MPD-1611291-A
EXACT-V2 High End Rack Modulator / Exciter
3/10/2017
MPD-1611291-A
Page 67/94
4.4
Initial Configuration
Except otherwise specified at the time of order, the exciter is delivered with the basic
configuration as described hereafter. The following configuration can also be retrieved
with the “Set Default” command (not available in the WEB GUI) that will only keep IP
settings and precorrection curves.
IP Parameters
Default Settings
Ethernet Mode:
Auto-sensing
DHCP
Disabled
Gigabit#1 Configuration:
(not changed by default command)
MAC address: module unique address
Address: 192.168.0.209
Subnet: 255.255.255.0
Gateway: 192.168.0.254
DHCP: OFF
Gigabit#2 SNMP
(not changed by default command)
MAC address: module unique address
Address: 192.168.0.211
Subnet: 255.255.255.0
Gateway: 192.168.0.254
DHCP: OFF
Gigabit#7 Front Panel Control
(not changed by default command)
MAC address: module unique address
Address: 192.168.0.210
Subnet: 255.255.255.0
Gateway: 192.168.0.254
DHCP: OFF
Gigabit#3 Input
(not changed by default command)
MAC address: Port#2 unique address
Address: 192.168.
1.210
Subnet: 255.255.255.0
Gateway: 192.168.1.254
Gigabit#4 Input
(not changed by default command)
MAC address: Port#2 unique address
Address: 192.168.
1.211
Subnet: 255.255.255.0
Gateway: 192.168.1.254
Gigabit#5 Input
(not changed by default command)
MAC address: Port#2 unique address
Address: 192.168.
2.210
Subnet: 255.255.255.0
Gateway: 192.168.2.254
Gigabit#6 Input
(not changed by default command)
MAC address: Port#2 unique address
Address: 192.168.
2.211
Subnet: 255.255.255.0
Gateway: 192.168.2.254
Gigabit #3, #4, #5, #6 Input
Time Out
1 sec.
Table 9: Default IP settings at the delivery
