Comau Robotics Product Instruction
68
MULTICONTROL PANEL
i.
At the end of the system power up, the new Virtual Controller is properly configured
and ready to be used.
5.2.2 Remove node
Select the Control Unit to be removed and click on the
Remove node
key .
Click
Yes
to remove.
5.2.3 Connect
The connection between PC and real Control Unit is based on the
TCP/IP
protocol.
When the physical connection is done, run
RoboShop
program.
Note that in case of Virtual Control Unit, the mentioned above physical connection is not
required.
If needed, some functionality
can be modified before connecting.
Click
Connection
key to connect to the Control Unit, as shown in the figure below.
Select the Control Unit to be connected and click the
Connect
key (figure below).
Insert
Username
and
Password
; click
OK
to proceed. The connection operation could
CAUTION
Roboshop
allows connecting MORE THAN ONE real Control Units at the same time
and JUST ONE Virtual Control Unit.