Operation Manual
Zwave Repeater
CM-ZR01
Introduction
Thank you for choosing the COMAX’s Zwave repeater. This sensor is a Z-Wave enabled device and is fully
compatible with Z-Wave
Every main powered Z-Wave enabled device acts as a signal repeater and multiple devices result in more possible
transmission routes.
This device take existing Z-WAVE signal, repeat and send it to a longer range where it is too far away for the
controller.
Product Description and Specification
Specification:
Protocol: Z-Wave
Frequency Range: 865.2 Mhz
Operating Range: Up to 100 feet line of sight
Operating Temp.: -10°C to 50°C
Operating voltage: 5V/DC,300mA
Command class:
COMMAND_CLASS_BASIC
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_VERSION
Installation
1.
Fix the repeater under the vertical way as high as possible then insert the suitable Micro USB Power
Adaptor, then it will go to the Learning Mode automatically. (The LED will start flash which means the
repeater has not been “Include” yet.).
2.
For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface.Controller into “ inclusion”
mode and following its instruction to add the repeater to your controller. To get in the “inclusion”
mode, the distance between module and controller is suggested to be in one meter. Press the program
switch on the repeater once. The LED should stop flashing, if not, please try again.
