INSTALLATION GUIDE FOR UHF DAS
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 24
⚫
Install the Mounting Rack to the wall.
⚫
Hang the equipment and secure the enclosure to the mounting rack.
Mounting Rack
Expansion Bolt
M10X110
Chassis
M8X25
,
Hexagon
Head
,
Flat Gasket
,
Pad
Pylons Screw
Wall
Figure 12: UHF PS DAS (MU and RU) Wall Mounting
3.3.5
DRIP-LOOP
Comba recommends that every horizontal cable entry to the equipment forms a 'U' before its entry to the equipment. Water
on the cable will drip down at the bottom of the loop and will not accumulate at the equipment connectors.
3.3.6
CABINET MOUNTING FOR EU
Installation dimensions of Expansion Unit for cabinet mounting is shown as below: