USER MANUAL FOR COMFLEX-5H00 1W2W
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 66
Step 8
: Click
to enter to [Finish] page after finishing RU setup.
Note:
As the system calibration process is calibrated for single channel, so if there is more than one same band
input, because of the power superposition, the band total output power will higer than target DL output
power after the calibration is complete.
The calibration work is mainly
to set device to reach it’s theoretical gain, so when there are two or more
same bands ac
cess into and they have the same input power level, each channel will reach it’s rated
power, so the total output power will be (input A
+gain) + (gain)+…+(gain). For example, if
there are two 1900MHz bands acess to MU, each has 10dBm input power, the total output power of RU
1900MHz will be 30dBm+30dBm=33dBm.
Refer to the method below for the gain adjustment:
Suppose a band with N independent inputs, each input signal power are all X dBm. Apparently, there
exists the following relationship between input and output after finished auto communication on WEB GUI:
X dBm + Gain = 30dBm, then the total output power for N channels access is X dBm + Gain + 10*Log(N)
= 30 + 10*Log(N), so Users need to set 10*Log(N) RFU ATT on WEB GUI for each channel.
End of Section
