37
Section 13 - Installing the Infant Car Seat Base Without The Base
38
Section 13 - Installing the Infant Car Seat Base Without The Base
Locking Clip
LAP ONLY BELT
Pass the belt from one side of the car seat to
the other. Place the vehicle seat belt under the
tabs of vehicle seat belt slots in front of the
handle.
Pull the lap belt tight!
LAP AND SHOULDER BELT
Pass the Lap belt from one side of the car
seat to the other. Place the lap belt under the
tabs of vehicle seat belt slots in front of the
handle.
Place a Locking Clip to the Lap and Shoulder
belts just above the vehicle belt latch.
Pull the lap belt tight!
NOTE:
• You MUST use locking clip provided with
this car seat with a vehicle belt that slides
freely through the latch plate or if the lap
portion of the lap and shoulder belt will
not stay tightly secured.
LOCKING CLIP (stored on back of seat)
Install car seat with lap/shoulder belt. Tighten
lap belt and while holding vehicle seat belts to
together at latch plate, unbuckle belt and slide
out of vehicle seat belt slots.
Slide vehilce seat belt out of vehicle seat belt
slots. Slide locking clip onto vehicle seat belts
approximately 1/2 inch (13 mm) away from
latch plate.
Slide vehicle seat belt back into vehicle seat
belt slots and re-buckle vehicle seat belt.
Test installation to see if car seat is secure.
Repeat above steps until car seat is secure.
Vehicle
Seat Belt
Slots
WARNING:
• Failure to use locking clip where
required will result in car seat not
being securely held in place.
• Remove locking clip from vehicle seat
belts when not being used with car seat.
• DO NOT use locking clip as a vehicle
seat belt shortener.
1/2 Inch
(13 mm)
