Section 7 - Securing Infant In Car Seat (continued)
15
• For proper harness fit:
- Shoulder harness slots MUST be positioned
at
or
just
below top of shoulders. Maximum 1 inch (25 mm) below
shoulders.
• Prevent serious neck injury or death from ejection. Top of
headrest MUST be at least 1 inch (25 mm) above top of
infant’s head at all times when installed in a vehicle.
• Headrest MUST be securely locked in position.
WARNING
- DEATH or SERIOUS INJURY can occur
To Adjust Headrest and Shoulder Belt Height:
1. Turn Headrest Adjustment Knob clockwise
(right)
until it stops. DO NOT overturn.
2. While holding knob, slide knob and headrest
up or down to desired position .
3. Release knob, check
to make sure headrest
is locked in place by
pushing headrest up
and down.
(fig. a)
1
1
2
Headrest
Adjustment
Knob
2
Section 7 - Securing Infant In Car Seat (continued)
16
7b. Securing Infant in Car Seat:
Loosen harness - Press Harness Adjuster Lever
by pushing on seat pad where it says “Press
Here” and pull harness straps out
(fig. a)
.
Open Chest Clip and unbuckle harness - press
red release button on Harness Buckle and pull
tongues out of buckle.
Place infant in car seat with back and rump
contacting seating surfaces
(fig. b)
.
Check that Shoulder Harness Slots are
at
or
just below
top of infant’s shoulders. See
“Shoulder Harness Adjustment for Proper Fit”
section. Maximum 1 inch (25 mm) below top
of shoulders.
To adjust, see “Harness - Changing Length,
Shoulder Harness Slots, and Removal” section.
Place Harness Straps over child’s shoulders
and thighs.
(fig. b)
(fig. a)
PR
ESS HERE
1
2
3
4
5
Harness
Adjuster
Lever
