Maintenance
100
C2500CB-OM-EN-16
Note
Before adding hydraulic oil, ensure that all cylinders are retracted fully then
fill to half way up the sight glass on the hydraulic oil gauge. Otherwise the
tank may be overfilled.
12. Apply a little hydraulic sealant to the
thread of a new strainer filter and fit the
new filter correctly inside the tank. Use a
genuine OEM component.
13. Inspect the O-ring seal (
D
) and replace
with a new seal if necessary.
14. Refit the panel (
B
) correctly with the O-
ring seal (
D
).
15. Add hydraulic oil through the filler neck
until the oil level is half way between the
top and bottom of the sight glass (
E
).
10. Refit the filler cap securely then close
the bonnet.
11. Check the hydraulic oil level again after a short period of operation.
Hydraulic Tank Capacity:
35 litres / 37 quarts
16. Dispose of waste oil and used filter elements in compliance with statutory
legislation.
Hydraulic Tank Breather
The hydraulic tank breather should be replaced at regular intervals in accordance with
the maintenance schedule.
To change the hydraulic tank breather:
1. Park the truck in a designated service
area
in
accordance
with
the
recommended parking procedure.
2. Lower the mast fully and tilt the mast
fully forward.
3. Switch off the engine, remove the key
from the ignition and wait until the
engine is cool enough to touch before
proceeding.
4. Open the bonnet from the right hand side of the truck to gain access to the
hydraulic tank breather (
A
).
5. Clean the used breather (
A
) and the surrounding area thoroughly before
removing the used breather.
6. Unscrew and remove the used breather from the end of the breather hose (
B
).
7. Fit a new breather.
B
C
D
E
A
B
