Technical
_____________________________________________________________________________________________________________________
121
C2500CB-OM-EN-16
Mode 3 – Switch Mode
Move Switch ‘3’ to the ‘ON’ Position
Park Brake
– LED 1
Mast Height Override Switch – LED 2
Mast Height Proximity Sensor – LED 3
The Park Brake will only remain lit while the park brake is engaged.
LED 2 will be ON constantly on all machines that do not have the Mast
Height Override Function.
To energise the mast height proximity sensor lift the forks to the height
of the proximity sensor.
Mode 4 – Solenoid Mode
NOTE:
This mode must only be used with the key turned on,
NOT
with the engine running.
Forward, Reverse, 0
and 90
Solenoids
Move Switch ‘4’ to the ‘ON’ Position to test.
Use the directional joystick to energise the solenoids as below
FWD Solenoid
0
Solenoid
90
Solenoid
REV Solenoid
Steering, Reflex, Carousel and Drive Solenoids
Move Switch ‘5’ to the ‘ON’ Position to test.
Steering Solenoid
Carousel Solenoid
Drive Solenoid
Reflex Solenoid
The LED on each solenoid should be lit along with the LED on the board.
If the solenoid LED does not light, a wiring problem may be present.
If the solenoid LED is lit but a problem remains the solenoid and/or the
valve should be checked for malfunction.
