Operation
64
C2500CB-OM-EN-16
Lift the pallet/load approximately 50-75mm
(2-3˝). If the load dips use the tilt function to
level the load before attempting to withdraw
it.
If the load is unstable use backward tilt to
secure it if appropriate.
Fully press the brake/inch pedal, select
reverse and check that the area behind the
truck is clear.
Press the accelerator pedal lightly to
increase the engine speed then gradually
release the brake/inch pedal until the truck
begins to move slowly in reverse.
Reverse, looking in the direction of travel.
Make occasional checks to prevent the
load from fouling on the racking or adjacent
loads on withdrawal. Make any necessary
adjustments (always apply the park brake
and select neutral before operating the
hydraulic controls).
Stop and apply the park brake when the
load is clear of the racking or stack.
Lower the load under control until the forks
are 100mm (4˝) above the ground.
Tilt the mast back before moving off.
