10
Rest the wooden pallet on the floor and, using a hex socket wrench, loosen and remove the bolts (if any) that fix
the appliance to the pallet (Fig. 2).
Lift the appliance using equipment fit to bear its weight. Separate the appliance from the wooden pallet and fit
the supplied legs into the housings on the base plate provided for the purpose (6 in Fig. 3).
Use a spirit level to ensure that the appliance is standing perfectly level. If necessary, adjust the legs.
5 INSTALLATION
5.1 CONNECTION DIAGRAM (Fig. 4)
7. electrical connection controlled by omnipolar circuit-breaker with residual current device
8. water tap
9. water supply pipe
10. water drainage pipe
5.2 POSITIONING
‼ The appliance must be installed in a hygienically clean location; it is advisable to avoid rooms like cellars and
store-rooms, because failure to meet hygiene requirements is likely to lead to the formation and proliferation
of bacteria in the appliance.
The appliance can operate at an ambient temperature of between 10°C and 43°C.
The best performance will be obtained by installing the appliance in a place with an ambient temperature of
between 10°C and 35°C and a water temperature of between 3°C and 25°C.
Avoid direct exposure to sunlight and do not install near heat sources.
‼ This appliance:
•
must be installed in a place where it can be supervised by skilled personnel.
•
must not be used outdoors.
•
must not be installed in damp places or where it is liable to be sprayed with water.
•
must not be cleaned with jets of water.
•
must be allowed a clearance of least 5 cm all around (this does not apply to the flush mounting models).
5.2.a POSITIONING FOR FLUSH-MOUNTING MODELS
Ventilation is ensured by the grille on the front panel; it is therefore not necessary to leave any gap, except to
facilitate installation.
A hole must be made in the surface where the appliance is to be located so that the power cable, water supply
pipe and the water drain pipe can be passed through as shown in Fig. 5. The plug and water supply and drain
connections are accessible from the front panel. To access these, disconnect the appliance from the power supply,
unscrew the screws that hold the front panel in place and after opening the door, pull out the panel from above
(Fig. 6).
Before fitting the appliance in place, the power cable must be fixed to the base plate as shown
in the diagram in Fig. 6:
•
pass the plug and cable (11) through the hole (12) in the plate
•
position the cable clamp (13) in its housing
Fit the front panel back in place after making these connections.
