9
In addition, proceed as follows:
•
Break off and remove the door in order to prevent the possible danger of a child getting trapped inside.
•
Do not allow the coolant gas and oil in the compressor to disperse into the environment.
•
Dispose of or recover the various materials according to the provisions established by the current laws in
force in your country.
This symbol means that this product should not be treated as a household waste. To prevent potential
negative consequences for the environment and health, be sure this product is correctly disposed of and recycled.
For information on the disposal and recycling of this product, contact your Distributor or the Waste Treatment
Service.
This appliance does not contain coolant that damages the ozone layer. This appliance contains fluorinated
greenhouse gases covered by the Kyoto Protocol. This product is hermetically sealed.
‼ The Manufacturer shall not be liable for any damage to the environment, animals, persons or objects caused
by incorrect installation.
2 TECHNICAL DATA (Fig. 1)
The voltage and frequency are given on the data plate on the appliance. Refer to this data plate to check
compliance.
Voltage (1), power (2), model (3), serial No. (4), Manufacturer (5).
The weighted equivalent continuous sound level A of this appliance is less than 70 dB(A). The measurements
were made over an entire production cycle, at a distance of 1 m from the surface of the appliance and at a height
of 1.60 m from the floor.
The wiring diagram is stuck on the front counterpanel of the appliance.
In order to gain access thereto, unplug the appliance from the power source, loosen screws holding the front
panel, and slide it away after first opening the door.
3 ADVICE ABOUT TRANSPORTATION
The net weight and the weight including packaging of the appliance are given on the cover of this manual. Please
refer to the instructions on the packaging in order to correctly transport and lift the appliance.
To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that the
appliance is kept upright during transport, storage, and handling. Follow the instructions given on the packaging.
4 UNPACKING
The appliance must be installed by authorized personnel, in compliance with the current laws in force and the
Manufacturer’s instructions.
Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT THE
APPLIANCE IS IN A PERFECTLY GOOD CONDITION. IF IN DOUBT, DO NOT USE IT AND IMMEDIATELY CONTACT THE
DEALER who sold it to you.
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed and put out
of the reach of children, as they are potential sources of danger.