13
Furthermore:
•
If there is excessive noise, make sure that the appliance is not touching furniture or sheet metal which can
give rise to noise or vibrations.
•
Should any trace of water appear, check the drain hole of the container to ensure that it is not clogged, that
the water fill and drain pipes are correctly connected and are not throttled or damaged.
•
Make sure that the temperature of the air or water does not exceed the installation limit values (see
paragraph 5.2).
•
Make sure that the water inlet filter is not clogged (see paragraph 9.1).
•
Make sure that the spray nozzles are not clogged with scaly deposits.
If the fault still persists after the above inspections have been made, turn off the electric power source by means
of the switch fitted during the installation phase, pull out the plug from its socket, turn off the tap connecting
the appliance to the water mains, and contact the nearest Authorized Technical Service Centre.
To obtain a faster and more efficient reply when you call the Centre, state the model of the appliance precisely,
together with its serial number or manufacturing number. This information is given on the serial N° plate (Fig. 1)
affixed to the rear of the appliance and on the cover of this manual.
8 OPERATION
The appliance has a thermostat probe in the ice bin, which stops ice production when the ice accumulated in the
bin reaches the probe connected to the thermostat. When ice is taken from the bin, the thermostat will
automatically reactivate ice production, thus creating a new supply of ice.
8.1 MODEL WITH CONTINUOUS DELIVERY (Fig. 10)
The appliance is equipped with an ice-cube dispenser (18) on the front. To take the required quantity of ice, place
a glass or a suitable container under the dispenser and press the button (19) to turn on the supply.
8.1.a ADJUSTING DISPENSED QUANTITY (Fig. 11)
‼ IMPORTANT:
•
The operations described below must be performed by a specialized technician, and only after disconnecting
the appliance from the electricity mains.
•
All operations that require handling of parts made of metal plate must be carried out wearing suitable gloves
to prevent cuts.
The appliance is provided with an electronic device for adjusting the quantity of ice dispensed each time.
To increase or decrease the dispensing time and the proportionate quantity of ice dispensed,
proceed as follows:
•
Remove the basin (20).
•
Slacken off the screws (21) on the front panel using a phillips screwdriver.
•
Pull out the front panel from above.
•
Turn the knob (22) on the electronic device clockwise to increase the quantity of ice dispensed whenever
the button is pressed, and anti-clockwise to reduce the quantity.
8.2 MODEL WITH COLD WATER DISPENSER (Fig. 12)
The appliance is provided with a cold water dispenser located beside the ice bin. To obtain cold water, place a
glass under the outlet and gently press the button (23) to turn on the water tap. Release the button to stop the
flow of cold water.
If the appliance is already provided with a filter located on the cold water supply circuit, read the instructions on
the filter label carefully and follow the manufacturer’s recommendations regarding the replacement schedules.
