14
1.6 PLAQUES
Check that the data specified on the plate correspond
to the characteristics of the power supply
(V, kw, hz, no. phases and power available).
1.7 POSITIONING
The machine must be installed and commissioned in complete compliance with safety regulations, procedures
and standing laws. The installation technician bears the responsibility of ensuring compliance with fire safety
requirements; seek all necessary advice from the local fire-fighting authorities. Position the machine in the
allocated site. Adjust the machine feet until the appliance is perfectly level. In the case of particularly heavy
equipment, use appropriate lifting means. If the appliance is not perfectly level, correct operation and
condensate flow-off will not be assured.
AVOID
Direct exposure to sunlight;
Closed sites with high temperatures and poor air circulation;
Installing the machine near sources of heat.
