Omega II
®
Installation, Operation & Maintenance
Combustion Research Corporation
Page 1
HEATER SAFETY
Please take time to familiarize yourself
this manual as your safety is important
is important to us. This symbol is used
throughout this manual to notify you of
possible fire, electrical, burn hazards or
other safety issues. Pay special
attention when reading this manual and
follow the warnings.
Read this manual carefully before installation, operation or
service of this equipment.
Protective gear (including safety glasses) is to be worn
during installation, set up and service. Sheet metal
components, including the aluminum reflectors and field cut
radiant tubes used on this system as well as various
venting components have sharp edges. The use of gloves
will also help in reducing the transfer of dirt and oils to the
surface of the reflectors.
If additional Installation, Operation and Service Manuals are
needed, contact your Combustion Research Corporation
independent representative or Combustion Research
Corporation. The IOM’s can also be found at
www.combustionresearch.com.
In order to help prevent personal injury and damage to the
heater components, at least two persons will be required for
installation.
SAFETY LABELS AND THEIR LOCATION
Product safety signs or labels should be replaced by the
end user or servicing contractor when they are no longer
legible or have been damaged. Please contact Combustion
Research Corp. or your Combustion Research Corp.
independent representative to obtain signs or labels.
Gas Connector Label
P/N 900.2712
Logo Label
P/N 900.2708
Bottom Panel
Wiring Schematic located inside Bottom Panel
P/N 900.27D
Summary of Contents for Omega II
Page 40: ...Omega II Installation Operation Maintenance Page 36 Combustion Research Corporation...
Page 48: ......
Page 49: ......
