Comdial DIGITECH System Manual Download

Page: 18 / 218

No class of service programming is required to enable

this feature.

AUTOMATIC DIALING

The system supports up to 22 auto dial positions per
station.

buttons can store up to 16 digits plus

an intercom or line selection. Stored digits include
9-0,

and #. A pause is stored at any point where the

HOLD button is pressed, and a hookflash is stored at

any point where the TAP button is pressed. Automatic
dialing can be used to provide one-button access to
system features. No class of service

programming is required to enable autodialing. Also
refer to discussions titled:

Automatic Pause Insertion,

Station Speed Dial, and Programmable

AUTOMATIC HOLD FOR INTERCOM

If the second intercom line is selected while a call is
active on the first intercom line, this feature causes the

first intercom call to be automatically placed on hold.

Station class of service programming is required to

enable this feature.

AUTOMATIC HOLD TRANSFER TO

INTERCOM (ANSWER HOLD)

If the intercom line is selected while an outside line

call is active, this system feature causes the outside
call to be automatically placed on hold. No class of
service programming is required to enable this feature.

AUTOMATIC HOLD TRANSFER TO LINE

This system feature is made available through
programming to selected stations. When enabled,
pressing any line button will cause an active line to
automatically go on hold. This feature allows a user to
move from line to line without having to press the
HOLD button to place any current calls on hold.
Station class of service programming is used to
enable this feature at the desired stations.

AUTOMATIC PAUSE INSERTION

When the system stores a dialed number for later
redial, it automatically stores a pause whenever the
user watts between digits for at least two seconds.
The automatic pause is inserted in the stored number
sequence at the point where the manual pause in
dialing occurred. The length of the pause is fixed at
two seconds by the system.

AUTOMATIC PRIVACY

A line can be made private or non-private through

programming. In the private mode, a station has

exclusive use of the line during a call.

No other Station

can access that line unless it is included through

the

Of System Features

66-083

use of the add-on conference feature. In the
non-private mode, another station with that line
appearance can gain access at the same time
(sometimes known as common line pickup). A line is
specified as private or non-private through the line

class of service programming. Through station class
of service programming, a line can be made

non-private at a particular station. Also see the

discussions titled:

Conference Add-On and Privacy

Release.

AUTOMATIC

OF BUSY

NUMBER OR UNANSW RED CALL)

A busy number or unanswered call can be
automatically redialed by activating this feature. Once
automatic redial is activated, the station will select the
line, automatically dial the number, and wait for a
response. It will do this once a minute for
approximately 10 minutes unless deactivated because

that button or another button is pressed or the handset

is lifted. The feature cycle is timed and does not have

busy detection circuitry. Because of this, if operating
handsfree when the called party answers, the handset
must be taken off-hook to prevent the caller from
being cut off by the timing cycle. Automatic redial is a
designated programmable button position and must be
programmed by the user to be active but no class of

service programming is required.

AUTOMATIC STATION RELOCATION

With this feature, the system will automatically

recognize a particular station should that station be
relocated to a new station port. When installed at the
new

location, the station will continue to provide

the same class of service parameters and respond
the same extension numbers as it did at the original

station port. This system feature is enabled with
system class of service programming.

AUXILIARY EQUIPMENT INTERFACE

A non-key system telephone device or a data device

can be connected to a line ahead of the common

equipment by using the auxiliary equipment interface.

The system can detect an off-hook condition in the