Comelit Icona Manager, Technical Manual

14

Other functions: button programming

Programming range

1.

2.

3.

4.

Min. address

S1

Set a code.

“Addressing 

table" on page 

17

S2

x4

OK prog:

x4

KO prog:

S2

Max. address

Cancellation

S1

S2

1.

Enable

2 sec

x10

x10

OK prog:

KO prog:

Disable

2 sec

Take note of the S2, S1 settings and restore on completion of programming

1.

To enter programming mode, set S2 DIP-switch 6 to ON.

» the LED 

 flashes

S2

2.

Refer to the table 

“Basic configuration"

 to identify a DIP-switch combination in which the desired functions corresponding 

to the buttons you want to program appear, then set the S2 DIP-switches.
Example: For button 4= Self Activation (AI) and button 5 = Call to Secondary Switchboard (CCS), set S2 DIP-switches 1-2-
3-4 as specified in row M in the "Basic configuration" table.

3.

Press and release the buttons involved in the change.

» Correct procedure indication

: the LED 

 flashes for a few seconds and a confirmation tone sounds.

4.

Exit programming mode by setting S2 DIP-switch 6 to OFF.

» LED 

 switches off

S2

5.

Set S2 DIP-switches 1-2-3-4 to ON.

When the procedure is complete, restore the initial DIP-switch combination.