Spacer A
10mm x 10mm
Spacer B
10mm x 6mm
Spacer C
6mm x 6mm
Spacer D
6mm x 3mm
SKETCH 1
B
B
C
C
Brake hanger holes
Mashima
MHK1015
Mashima
MHK1015
GB4
GB5
To split the rods over the centre crankpin cut the backing rod at A-A, solder to the corresponding
halves of the outer rods and connect both halves at the centre crankpin.
To split the rods on the knuckle joint first drill through the half-etched centres on the knuckle and
cut the backing rod at B-B. Solder the inner and outer halves together then join the front and back
halves of the rods using a pin or rivet (not supplied) so that the rods are articulated behind the
centre crankpin.
SKETCH 2
Suggested pick-up arrangement
Rear half
A
A
Front half
B
B
Rear half
Front half
Plain inner rod
Outer rod. Note
half-etch to
outside
SKETCH 3
Fit pick up busbars here
Fitting hornblocks
SKETCH 4
SKETCH 5
Suggested
body fixing
method
Note – the 80
thou thickness
of plasticard
can be
obtained by
using two
layers of 40
thou material.
20 thou
plasticard
8BA nut
80 thou
plasticard
20 thou
plasticard
plasticard
blocks
