2
•
Keep these operating instructions! The manual contains important instructions on the use of the
UPS that should be followed during installation and use of the UPS device and batteries.
•
Condensation may occur if the power supply is cold and is brought into a warm place. Therefore,
you should wait at least 2 hours until it starts up.
•
To reduce the risk of electric shock, the UPS should be installed in a pollution-free room with
adequate temperature and humidity. The ambient temperature must not exceed 40 ° C.
•
Do not install the power supply in a place exposed to direct sunlight or other heat sources.
•
Do not connect devices that can overload the UPS output, e.g. laser printers, electric heaters, etc.
•
Cables should be connected and arranged in such a way that no one can accidentally step on or
disconnect them.
•
The UPS must be connected to the electrical system with an efficient protective earth (GND).
•
Do not block the ventilation openings on the UPS. Make sure the vents are exposed and there is a
minimum of 25cm free space for free ventilation.
•
The UPS power circuit should be protected with an appropriate overcurrent circuit breaker.
•
The UPS has its own battery power source, so there may be voltage on the output strip, even
though the UPS is not connected to the mains.
•
Battery handling should be performed by trained personnel who are knowledgeable about battery
operation and take appropriate precautions during its use.
•
If it is necessary to replace the battery, use batteries of the same number and parameters, i.e. rated
voltage, capacity and dimensions.
ATTENTION!
Do not throw batteries into fire. The battery may explode.
ATTENTION!
Do not open or mutilate the battery.
Released electrolyte is harmful to the skin and eyes and may be toxic.
•
The battery can present a risk of electric shock. The following precautions should be taken when
working with batteries:
o
Remove watches, rings and other metal objects from your hand.
o
Use tools with insulated handles.
o
Wear rubber gloves and boots.
o
Do not lay tools or metal parts on top of the battery.
o
Disconnect the battery charging source before connecting or disconnecting the battery
terminals.
•
Check that the battery is not inadvertently grounded. If present, remove the source of the ground
fault. Contact with any part of a grounded battery can result in electric shock.
