COVER MY SERIES – User Manual
COMEX S.A.
3
2.
Installation procedure
This chapter is devoted to the method of installation, mounting and wiring of the UPS.
2.1.
Introduction
This chapter presents the basic requirements for the location and cabling of the power supply.
The description presents a step-by-step installation manual, which is a series of guidelines that
should be followed by the service when installing the device.
Warning - Installation may only be performed by an authorized service
center
1. Do not connect electrical appliances to the power supply until the service technician has
verified that the power supply is properly connected and configured.
2. The UPS should be installed by qualified technical personnel in accordance with the
guidelines contained in this chapter.
Do not perform any electrical work interfering with the electrical system upstream and
downstream of the UPS while the UPS system is operating. Damage resulting from this (eg
change of the phase sequence) is not covered by the warranty.
Warning: Dangerous Batteries
Particular precautions must be taken when working with batteries connected to the power
supply. When the battery is connected, the terminal voltage exceeds 400 Vdc and is
potentially lethal.
To protect the eyes against an accidental electric arc, it is recommended to wear protective
glasses. Additionally, it is recommended to:
Remove rings, watches and all metal items
Only use tools with insulated handles.
If the battery leaks or is otherwise damaged, it must be replaced. Damaged batteries
should be stored in a sulfuric acid resistant container and disposed of in accordance with
local regulations.
If the electrolyte comes into contact with the skin, wash the contaminated area immediately
with water.
2.2.
Initial inspection
Please perform the following checks prior to installation:
Visually check that the delivered devices, i.e. the UPS and the batteries, have not been
damaged during transport. Any damage found should be reported to the supplier
immediately.
Verify the compliance of the supplied equipment with the installation requirements. The
power of the power supply is each time described on the label.
警告
危 险
警告
危 险