14
Step 3:
Press the “Up“ button (ON/MUTE) to switch to "02" of
program list. Then press “Enter“ button to enter value
setting of parameter 2. Press the “Up” button to change the
value to “ENA” to enable the programmable outlet function.
Then press “Enter” button again to confirm the setting.
Step 4:
Press the “Up“ button (ON/MUTE) again to switch to "03" of
program list. Then press “Enter“ button for setting
programmable outlet time. Push “Up” button to change the
value of backup time according your demand. Then press
“Enter” to confirm the setting.
Step 5:
Press “Up“ button (ON/MUTE) to switch to "00" of program
list. Then press “Enter” button to exit setting menu.
Step 6:
Disconnect AC input and wait until the LCD display is off. The new setting will be activated
when turning on the UPS again.
3-6. Operating Mode Description
Operating mode Description
LCD display
ECO mode
When the input voltage is within voltage
regulated range, UPS will power the
output directly from the mains. ECO is an
abbreviation of Efficiency Corrective
Optimizer. In this mode, when battery is
fully charged, the fan will stop working for
energy saving.
Buck mode
when AC is
normal.
When the input voltage is higher than the
voltage regulation range but lower than
high loss point, the buck AVR will be
activated.
