1. Attach the massager to a chair with elastic straps or place it on other support.
2. Connect the adapter cable to the corresponding cable on the cushion.
3. Plug the home adapter into an electric outlet.
4. Turn on the device using the controller ( instructions on page 5 ).
5. When finished place the controller in the pouch at the side of the cushion.
6. You also may soften the massage pressure by placing a blanket or towel between you
and the device.
•
You should allow your body some rest periods. To avoid straining your muscles
too much, we recommend to Not exceed a continuous massage of 15 Minutes
per time and Not exceed 3 times use one day.
• The device will automatically switch off after 15 minutes timer run out.
• Remove the adapter from the outlet when not in use.
• Do not setup or use the massager in a bathroom or similary wet / damp areas.
①
②
① Place a blanket or towel between you and the massager to achieve a far softer massage
intensity if you still feel too strong shiatsu after installing the flap onto the cushion.
② If you want to massage your lower back, but the shiatsu nodes can not reach that low.
You may adjust the height of your back when sitting, by placing a seat cushion or a pillow
on the sitting part.
! Attention
If the shiatsu can’t reach your lower back area
If the Shiatsu is too strong,
Seat cushion
3
Setup and Operation
! Attention
Blanket
/Towel
