5
Setup and Opera�on
• Do not setup or use the device in a bathroom or similary wet / damp areas.
• Please choose a chair with desired height and be seated, then put your feet on the
product.
• Operate below control panel to get foot massages.
1.Power bu�on: Press this bu�on to turn on or turn of the product;
Default massage mode: 15 minutes, roller speed L block, air pressure L block, full foot
hea�ng mode open, corresponding indicators are always on (red);
2.Timer bu�on:The �mer is 15 minutes by default, and the indicator is red;
Press this key to switch to a 30-minute shutdown,and the indicator is blue;
The �ming interval switches between 15 and 30 minutes.
3.Rolling massage mode bu�on: Press this bu�on,The default roller
speed is L (low speed), ; Press this key to switch to M (medium speed);
Press this key again, switch to H (high speed). Follow the "L→M→H→L" cycle,the
corresponding indicator is red on
4.Airbag control bu�on: In the boot state, the default pressure
is L block (low pressure), ; Press this key to switch to M (moderate pressure);
Press this key again, switch to H (high pressure); Follow the "L→M→H→L" loop
switch,Follow the "L→M→H→L" cycle,the corresponding indicator is red on.
5.Hea�ng bu�on: Press this bu�on to control the hea�ng func�on; When the product
is turned on, the default temperature for hea�ng func�on is 45-50
℃
(113-122
℉
)
with blue indicator light on; If you feel that the temperature is low, press this bu�on
again. If the red indicator light is on, the temperature for the hea�ng func�on would
be 50-55
℃
(122-131°F).
Note:
Timer
Heat
Power
Kneading
Air intensity
1
4
5
3
2
