background image

Installation & Operation Manual 

Infrared Electric Patio Heater 

2

WARNINGS

This electric appliance produces infrared heat and failure to follow warnings and 

READ AND SAVE THESE INSTRUCTIONS!

WARNING

FIRE OR EXPLOSION HAZARD

Failure to follow safety warnings exactly could

result in serious injury or property damage.

 

vapors or liquids in the vicinity of this appliance.

 

materials on, or allow them to come in contact 

with, the unit: rags, fabrics ,spray or aerosol cans, 

cleaning compounds, plastics or plastic containers, 

Do not install the heater close to furniture, curtains

Do not cover or otherwise obstruct the heater.

WARNING

PERSONAL INJURY HAZARD

Do not touch the heater during operation. Burn or

scald injury could result.

Keep children away from the heater. Never leave

an unsupervised child near the heater.

Because of injury risk, the heater should be

operated only by individuals knowledgeable about

the operation and familiar with the warnings and

cautions listed in this manual.

Because of injury risk, this heater is not intended

for use by persons with reduced physical, sensory

or mental capabilities.

WARNING

PERSONAL INJURY HAZARD–SERVICE

To avoid property damage, personal injury or death

due to electrical shock, do not service the unit

and allowing adequate time for the unit to cool down.

 

service technician.

Do not use the heater if the power cord is

damaged. Contact an authorized servicer or

electrician to replace the cord prior to use.

WARNING

INSTALLATION & USE

To avoid property damage, personal injury or 

death due to electrical shock, all instructions in this 

Installation and Operation manual.

All local, regional and national electric codes and

local construction codes must be observed in the

installation of the heater.

The power outlet must be properly polarized and

grounded.

Be sure the voltage listed on the heater’s

nameplate is the same as the voltage at the

installation site.

Do not use the heater if the power cord is

electrician to replace the cord prior to use.

Remove the plug from the power outlet and wait

CAUTION

Never use with an extension cord or multi-socket.

Use extreme caution whenever the heater is left

operating and unattended.

Do not install the heater immediately below a wall

socket outlet.

Do not use a timer or other device that

automatically turns on the unit.

Do not use the heater with an external voltage

regulator such as a dimmer or speed controller.

AITONS EQUIPMENT

Summary of Contents for IRPH15SS









Reviews: