Remove cardboard lid, outer box sleeve, and packing foam.
Inspect for any shipping damage. (Preferably before delivery
team leaves)
Unscrew the mounting L brackets that secure the rear of the
stove to the pallet. (4mm Allen)
Open hopper lid and remove control panel, power cord, remote
control, and all literature and packing material from the hopper.
Open the front door via the latch on the right side behind the
magnetic side panel (see picture) and remove cardboard
packing material from the firebox chamber.
Remove any tape or adhesive on the outside of the glass.
Unpacking:
8
Installation
Pre-Installation
Installation MUST comply with local, regional, state and national codes and regulations.
Consult insurance carrier, local building inspector, fire officials, or authorities having jurisdiction over
restrictions, installation inspection and permits.
Pro Tip: It is recommended that your pellet vent pipe be installed and serviced by a professional installer.
Placement:
Where you place your stove can significantly affect its performance and safety.
Sketch out a plan for installing the stove, including dimensions, before permanent placement. When
determining the location for the stove, wall stud location is critical. You may need to adjust the location of the
stove to avoid encountering a wall stud. Before placing the pellet stove, connect the vent to allow for minimum
clearances to combustible walls.
Front Door Latch
WARNING!
Asphyxiation Risk:
DO NOT INSTALL IN A SLEEPING ROOM.
Stove consumes oxygen in the room.
Notice: Clearances may only be
reduced by means approved by the
regulatory authority having jurisdiction.
Installation
It is recommended that you
install a flexible liner for
easier cleaning and
maintenance of the pellet
stove insert.
If rigid piping is used, the
stove will not be able to be
pulled out for routine
maintenance and cleaning.
You can also install a rear
access door into the
chimney space to avoid
having to pull the stove out
for cleaning and
maintenance.
Pro Tip:
Summary of Contents for HP22i
Page 2: ......
