Comfortflame.US.com
900578-00_NC
8
Burner Inlet
Fitting
Front
Burner
Burner
Manifold
Burner Pan
(Front)
Gas Connection
Must Be On
Right Side For
Triple Burner
TRIPLE-BURNER
Burner Manifold
Knockout
Plugs
Burner Pan
(Front)
Burner Inlet
Fitting
SINGLE-BURNER
Burner Inlet
Fitting
Screw
Nut
Burner Clamp
Burner Pan
(Front)
Knockout
Plugs
DUAL-FLAME
Burner
Manifold
Figure 6 - Installing Burner
INSTALLATION
Continued
Installation and Gas Connection
1. Place burner pan assembly in center of fireplace floor. Make sure
front of pan faces forward.
2. Thread gas supply fitting to fireplace gas supply pipe. Use thread
sealant.
3. Install adapter fitting onto burner inlet fitting using thread sealant
on male threads of burner inlet fitting (see Figure 7). Adjust to
most convenient position.
4. Install gas connector tube to gas supply fitting. Carefully shape
tube to attach to adapter fitting. Be careful not to cause kinks in
tube.
Figure 7 - Connecting Gas to Appliance
Adapter
Fitting
Gas
Connector
Tube
Burner Pan
Assembly
(Facing Front
of Fireplace)
OPTIONAL GA9050A-1 (F0235) ON/OFF SAFETY VALVE/PILOT KIT
ASSEMBLY
For additional convenience and safety, or for propane/LP conversion,
an optional ON/OFF safety valve/pilot kit is available. See Accessories,
page 17.
WARNING: You must use a ON/OFF safety valve/
pilot kit for propane/LP conversion.
Natural Gas Installation
1. Thread gas control valve onto burner inlet fitting (see Figure 8,
page 9). Use thread sealant on male threads of burner inlet fitting.
Hold burner inlet fitting with a wrench to prevent overtightening
connection to the burner. Make sure control rod is facing the front
(see Figure 8, page 9).
2. Attach pilot gas line to pilot outlet of gas control valve and tighten.
Connect thermocouple to rear of gas control valve. See Figure 9.
Do not overtighten. If using propane/LP gas, see Changing Pilot
Orifice, page 10.
3. Install inlet fitting into inlet opening of gas control valve (see
Figure 10, page 9). Use thread sealant on male pipe threads.
4. Place burner pan assembly in center of fireplace floor. Make sure
front of pan faces forward.
5. Thread gas supply fitting to fireplace gas supply pipe. Adjust to
most convenient position.