background image

1.Read all instructions before using this 
appliance.

2.This appliance is hot when in use.  To avoid
burns, do not let bare skin touch hot surfaces.
Keep combustible materials, such as furniture, 
pillows, bedding, papers, clothes, and curtains at
least 3 feet from the front of this appliance.

3.

CAUTION:   Extreme caution is necessary

when any heater is used by or near children
or invalids and whenever the heater is left
operating and unattended.

4.

Always unplug heater when not in use.

5.

Do no operate any heater with a damaged

cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner

.

6.Any repairs to this appliance should be carried
out by a qualified service person.

7.Under no circumstances should this electric 
fireplace be modified.  Parts having to be
removed for servicing must be replaced prior to
operating this electric fireplace again.

8.Do not use outdoors.

9.This heater is not intended for use in bath-
rooms, laundry areas or similar indoor locations.
Never use this appliance near a bathtub or 
vicinity of water.

10.Do not run cord under carpeting.  Do not cover
cord with throw rugs, runners or the like.  Arrange
cord away from traffic areas and where it will not
be tripped over.

11.To disconnect this appliance, turn controls to
the off position and remove plug from outlet.

12.Connect to properly grounded outlets only.

13.When this appliance is installed, it must be
electrically grounded in accordance with local
codes with the current CSA C22.1 Canadian local 

codes for USA installations.  Follow local codes
and National Electrical Code, ANSI/NFPA NO.70
and Canadian Code, CZ 22.2 No. 0.

14.Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause electric shock, fire or damage to the 
appliance.

15.To prevent fire, do not block air intakes or
exhaust in any manner.  Do not use on soft 
surfaces, such as a bed, where openings may
become blocked.

16.CAUTION:  This appliance gets hot and it 
contains internal parts that could arc or spark.  
Do not use it in areas where gasoline, paint, or 
flammable liquids are used or stored.  This 
electric fireplace should not be used as a drying
rack for clothing.  Also, do not have Christmas
stockings or decorations hung on or near it.

17.Use this appliance only as described in this
manual.  All other uses not recommended by the
manufacturer may cause fire, electric shock or
injury.

18.Avoid the use of an extension cord because it
may overheat and cause a fire hazard.  However
if you must use an extension cord, the cord shall
be 16 AWG, 1875 Watts.  The extension cord
must be a three wire cord with grounding type
plug and cord connector.

19.

SAVE THESE INSTRUCTIONS

.

LOCATING YOUR ELECTRIC FIREPLACE

Your new freestanding electric fireplace may
be installed virtually anywhere in your home.
However, when choosing a location for your
new electric fireplace, ensure that the general
instructions are followed.  For best results,
install the electric fireplace out of direct 
sunlight.

2

I

MPORTANT SAFETY INSTRUCTIONS

GENERAL

Summary of Contents for ES4011








Reviews: