Comfort Heat CTAV-10, Installation Instructions Manual

Picture 2

. Renovated floor heating installation 

1. Sub-floor or existing floor

2. Layer of concrete

3. Thermostat sensor (in sealed 

pipe)

4. Heating cable

5. Layer of adhesives or self-levelling 

compound

6. Tiles or other flooring material

4. ACCUmULATED HEATING INsTALLATION

Accumulated heating of floors is designed for heating floors in residential houses, 

offices,  industrial  premises,  etc.,  where  is  the  possibility  to  use  night  low  tariff 

electric energy. Heating cables are installed into thick (7-15cm) layer of concrete 

(

Pic. 3

) which accumulates heat during the low tariff period.

Picture

 3. Accumulated floor heating installation

1. Base

2. Thermo insulation

3. Concrete

4. Thermostat sensor (in sealed pipe)

4. Heating cable (in concrete)

6. Damp protection (in bathroom)

7. Glue or sel-levelling compound

8. Tiles or other flooring

Usually installed power for accumulated heating is 150-200W/m

2

.

5. BEFORE HEATING CABLE INsTALLATION YOU HAVE TO 

• 

Check if the product in the package corresponds to one indicated on the 

package label.

• 

Measure the resistance of heating cable and its insulation. Resistance of the 

cable has to correspond to the value indicated on the product label (+/- 5%). The 

value of resistance has to be not less than 0,5 MΩ.

• 

Cut the channel in the floor and wall till the thermostat junction box for sensor 

pipe and cable connection wires.

• 

Clean floor from sharp things.

6