- 15 -
Version: May 2011
9.
Open the air bleed fitting on the
top of the filter housing. Leave the
bleed fitting open for one minute, or
until water drips from the bleed
fitting.
Close the bleed fitting.
10.
Plug the power pack into the
electrical outlet.
11.
Finally, reset the desired
temperature set point.
GFCI (120 volt units only)
The GFCI, or Ground Fault Circuit
Interrupt, fitting on the power pack
electrical cord should be tested
monthly. There are no user
serviceable parts inside the GFCI.
Do not open the GFCI as this will
void your warranty.
To test the GFCI, use the following
procedure.
If the GFCI device does not
function properly, do not use your
spa. Call the dealer or factory
immediately for instructions. Do
not bypass the GFCI device.
1.
Turn on the turbo wave blower.
2.
Push the test button on the GFCI
located at the end of the power cord.
The GFCI light should go out and the
turbo wave blower should shut off.
If the GFCI light does not go out, and
the turbo wave blower does not shut
off, the GFCI is faulty.
Do not use the spa. Immediately
contact your dealer or the factory for
instructions.
3.
Press the reset button on the
GFCI. The light on the GFCI should
turn on. If the GFCI light does not
turn on the GFCI is faulty. Do not
use the spa.
Immediately contact your dealer or
the factory for instructions.
There are no user serviceable parts
in the GFCI. DO NOT open the GFCI
as this will void the warranty.
Meijer.com
