- 8 -
Version: May 2011
SPA ASSEMBLY
*
Please note if fitting your spa with
colored skin you must first inflate spa
50% and then place skin over wall edge.
1. Take all parts out of box. Compare
package contents with contents
diagram found on previous page.
2. Unfold spa vessel (4), inflation
connection cover (7), and inflatable
inner cover (5).
3. Remove label(s) from liner-to-
power pack union nut.
4. Attach the three (3) feet to the
bottom of the power pack.
5. Connect the inflation hose to the
blower exhaust fitting on the top of
the power pack.
The key lock pin must be inserted
into the adapter of the inflation
hose fitting when inflating. Failure
to insert the key lock pin may
result in injury.
6. Plug the power pack into the
electric outlet. Press the Turbo Wave
On/Off button to start the inflation.
Note: The power pack will make a
rattling noise while the pump is
running with no water. This is
normal. Do not run the power
pack without water for more than
15 minutes.
7. Using adapter shown, inflate spa
vessel (4).
Note: Please note power
pack will inflate vessel
approximately 80% full. Shut
off air blower and finish
inflating with hand pump
provided using pressure
gauge. * Inflate to yellow zone
on pressure gauge.
8. Using power pack and inflation
hose, fill inflatable inner cover and
connection cover until firm. * Do not
over inflate!
9. Place white foam pad under spa
vessel.
Meijer.com
