ASSEMBLY & OPERATION
ASSEMBLY
1. Remove any plastic packaging from the Comfortel Salon Vac.
2. Connect Powercord to foot pedal as shown in Diagram 1.
3. Fit the power connection plug of foot pedal into the socket at the
rear of the unit.
4. Plug in the power cord in a standard 240V wall socket.
5. Ensure the green filter is on place inside the bottom of the canister,
and a bag is securely fitted.
6. The lid of the unit must be down firmly to ensure the best vacuum
suction
OPERATION
1. Ensure the bag and lid are firmly fitted.
2. For main power, press the red ‘ON/OFF’ switch located at
the back of the unit into the ON position to turn on the device as
shown in Diagram 2.
3. Sweep hair to the vacuum vent at the front of the unit
4. Press down on the foot pedal to activate the vacuum as shown
in Diagram 3.
5. When not in use, turn OFF from the main power switch.
REPLACING THE BAGS (DIAGRAM 4)
If you notice that the bag is getting full, or the vacuum suction of
the unit is low, it is time to replace the bag.
1. Turn off power supply before replacing the bag.
2. Lift the lid of the unit and slide the cardboard collar of the full
bag off the white vacuum tube.
3. Dispose of the full bag responsibly.
4. Unfold the new bag and extend it fully. The bag should be
opened out completely before fitting into the unit. If this is
not done the unit will not operate at its full capacity and the
strength of the vacuum suction will be affected.
5. Place the new bag into the canister and push the cardboard
collar of the bag at the top firmly over the white suction tube.
Ensure the bag is fitted as far as it will go along the tube, right
up to the round ring of the tube.
6. Put the lid down and make sure its firmly fitted to ensure
maximum vacuum suction.
7. Turn the power on and resume normal use.
Salon Vac Replacement Bags can be ordered from Comfortel.
CONNECT
TO BACK OF
SALON VAC
DIAGRAM 1
DIAGRAM 2
DIAGRAM 3
DIAGRAM 4
CONNECT
TO
WALL SOCKET
