|
EN
17
2. Installation instructions
2.1.
Assembly of water pump and base plate
Secure the water pump to the base plate with the provided pump mounting hardware. (Figure 5)
2.2.
Pump fittings assembly
1. Refer to figure 6.
2. Screw the 1¼
"
-1½
"
hose connector into the center port of the water pump. Ensure that the O-ring A is
installed between the port and the connector.
3. Remove the threaded ring (collar) on the outer opening of the pump.
4. Place O-ring B in the groove around the hair and lint strainer basket.
5. Place the transparent hair & lint strainer cover in place and then screw the threaded ring (collar) back on
securely over the cover.
6. Insert O-ring C (1¼
"
) inside the outward facing opening of the transparent hair & lint strainer cover.
7. Screw the 1¼
"
-1½
"
hose connector into the opening of the transparent hair & lint strainer cover.
2.3.
Filter tank assembly
1. Attach the filter tank to the base plate as shown (figure 7). The feet on the bottom of the filter tank fit within
the holes provided on the base plate.
2. Screw the filter basket onto the central pipe (figure 1). Fix the central pipe with the filter basket onto the
bottom of the filter tank (figure 2). Fill the tank with filter balls which provided in the package (figure 3).
3. Securing filter assembly (figure 4). Ensure the main tank seal around the top of the filter tank is in good
condition and securely seated in the groove. Be sure groove is free of sand. Carefully place the tank cover
onto the filter tank. The tank cover should be oriented so that the notch on the cover is aligned with the
matching tab on the filter tank - this ensures proper alignment. Secure tank cover and filter tank with the
tank cover lock ring assembly and tighten with the knob and bolt.
2.4.
Hose connection
This pool filter system is designed to connect to pools with standard 1 ¼" or 1 ½" diameter hose connectors.
If your pool has a hose connector size and/or type different than described here, you may need to purchase an
adapter at your local pool supply store or hardware retailer.
Before you begin to connect hoses to the filter and pump, make certain that no water can flow through the
intake or return hoses connected to the pool. Some pools have shut off valves in their intake and return ports,
others do not. If you do not have a shut off valve, block the ports with a removable plug to prevent water from
passing into and through the hoses.
1.
Attach the hose coming from your pool’s skimmer (outlet of pool) to the 1 1 ¼" - 1 ½" hose connector
extending from the hair & lint strainer cover.
2. Secure with a hose clamp.
3. Lightly lubricate the pool return port on the tank cover with synthetic PTFE lubricant, available at any pool
supply store or hardware store.
4. Attach the pool return hose (inlet of pool) to the pool return port on the tank cover.
Summary of Contents for FuzzyClean 7000
Page 1: ...FuzzyClean 7000 9500...
Page 10: ...NL 10 7 Installatie illustraties...