How to use the emergency stop switch
After the test file is opened, the software interface is as follows.
Control the spindle head to move to the
center of the engraved material, as shown below, the red box is the safety range of the engraved material
(excluding the space occupied by the fixture), the center of the red and green coordinate arrow is the origin
of the tool path position.
Then move the spindle head (without mounting the milling cutter) to this position of the material.Raise the
Z-axis to avoid running into the fixture screws. Finally, clear the parameters of each axis and click "Send" ,
then the toolpath starts to run.
When the machine is working abnormally, press the red E-stop to avoid damaging the machine and
project.
Then turn clockwise to release the E-stop, click
"Reset" and the status will change to"Alarm".
Click "Unlock" and the status will change to
"IDLE". The machine will return to normal
status.
20
21
7.Start Running
Observe the tool path operation window at the top left of Candle, the moving dotted line is the line of
machine operation. lf you find the toolpath deviates, turn off the power immediately and check whether
the coordinate direction of each axis is correct.
When running an empty toolpath, pay attention to see if the milling cutter will collide with the hold-down,
because in the real engraving process, the mills hitting the hold-down will cause tool breakage and even
damage the machine.
lf it is found that it may come into contact with the platen, adjust the home position again.
The butterfly nut should be kept at least
10mm from the engraving work area.
NOTE: lf you want to hollow out the carving, remember to pad a flat board
under the carving material to avoid the milling cutter hitting the work bench.
Summary of Contents for CNC Carving Machine
Page 1: ...User Manual V1 1...
