4K Switcher with Soft Codec & Matrix Outputs
45
8. Firmware Upgrade
Note: When upgrade Transmitter firmware, it need to be powered via Receiver, so
Receiver should be powered well and provide power via HDBT port to Transmitter.
Transmitter:
1) Prepare the latest upgrade file (.bin) and rename it as
“FW_MERG. bin” on PC.
2) Power off the switcher and connect the
FIRMWARE
port of switcher to the PC with
Type-A USB cable.
3) Power on the switcher and then the PC will automatically detect a U-disk named of
“BOOTDISK”.
4) Double-click the U-disk, a file named of
“READY.TXT” would be showed.
5) Directly copy the latest upgrade file (.bin) to the
“BOOTDISK” U-disk.
6) Reopen the U-
disk to check the filename “READY.TXT” whether automatically
becomes
“SUCCESS.TXT”, if yes, the firmware was updated successfully, otherwise,
the firmware updating is fail, the name of upgrade file (.bin) should be confirm again,
and then follow the above steps to update again.
7) Remove the Type-A USB cable after firmware upgrade.
8) After firmware upgrade, the switcher should be restored to factory default by sending
command.
Receiver:
1) Prepare the latest upgrade file (.bin) and rename it
as “FW_MERG. bin” on PC.
2) Power off the switcher, and connect the
FIRMWARE
port of switcher to the PC with
Micro USB cable.
3) Power on the switcher, and then the PC will automatically detect a U-disk named of
“BOOTDISK”.
4) Double-click the U-disk, a file named of
“READY.TXT” would be showed.
5) Directly copy the latest upgrade file (.bin) to the
“BOOTDISK” U-disk.
6) Reopen the U-
disk to check the filename “READY.TXT” whether automatically
becomes
“SUCCESS.TXT”, if yes, the firmware was updated successfully, otherwise,
the firmware updating is fail, the name of upgrade file (.bin) should be confirm again,
and then follow the above steps to update again.
7) Remove the Micro USB cable after firmware upgrade.
8) After firmware upgrade, the switcher should be restored to factory default by sending
command.
