Command access FLP-UL-M-KIT, Insert Instructions

Next, plug in the push & go connector into  

the MM4S

Set PTS instructions below 

CONTINUED

mm4s switches

2

on
on

off

STANDARD TORQUE

HIGH TORQUE

PTS PROGRAMMING LOCKED

PTS PROGRAMMING on

off

1

# 2 0 3 8 7 _ C

U S   c u s t o m e r   s u p p o r t   1 - 8 8 8 - 6 2 2 - 2 3 7 7   |   w w w. c o m m a n d a c c e s s . c o m   |   C A   c u s t o m e r   s u p p o r t   1 - 8 5 5 - 8 2 3 - 3 0 0 2

11.

12.

Setting PTS

Step 1-

Select your preferred torque mode (ships in standard torque) Press the device push pad to the 

desired setting. (Recommend to fully depress and release 5%, giving the device room for  

changing door conditions.)

Step 2-

 While depressing the push pad, apply power. (i.e. presenting the credential to the reader).

Step 3-

 Continue to keep pad depressed, the device will beep 6 times. After the beeps have stopped, 

release the pad and now the adjustment is complete. If not to your liking repeat the three  

steps. 

Step 4-

 Once you found the correct location, flip the dip switches to off to lock programming.