Now, with device reassembled set the PTS by pressing the red button & applying power. You will hear one quick beep to
let you know it is now in programming mode.
15.
Next, depress the push pad to the location you want the device to retract to & hold it there. Apply power & you will hear one
LONG beep. The device has now learned that location.
16.
Installation Instructions
Fire off the device a few times to ensure the location is correct. after installing the device on the door, recheck to verify
the pushpad is retracting to the desired location. If not, repeat steps 15-16.
17.
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w . c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
PTS Button
Step 1 -
To enter PTS mode: Depress MM5 button & apply power. The device will emit 1 SHORT beep. The
device is now in PTS mode.
Step 2 -
While depressing the push pad, apply power. (i.e. presenting the credential to the reader).
Step 3 -
Continue to keep pad depressed, the device will emit 1 LONG Beep. After the beep has stopped,
release the pad and now the adjustment is complete. test the new location, If not to your liking
repeat the 3 steps.
Setting PTS
**Important Info**
Make sure to set PTS before finishing installation
MM5 BUTTON
POWER
PTS
MM5
