USER GUIDE
10
Installation Notes
The
SHADOW
RTB
weighs approximately 75 pounds. Use mechanical assistance such as a forklift or
crane to lift the light into installation position.
Use the provided fender washers under the mounting surface to distribute the weight load evenly.
When routing the connecting electrical wires take care to avoid sharp bends, hot components or other
hazards to the wire.
The
SHADOW
RTB
is not designed to be operated in a raised position while the vehicle is in motion.
The
SHADOW
RTB
includes warning circuit wiring to enable a warning device.
Location Requirements
The standard
SHADOW
RTB
can be mounted on any location that is 34" x 22". The surface should be flat
or have only a slight crown. For a recessed installation allow for a minimum of 60" x 38". Consult with
factory before construction of recessed installation. Verify all dimensions before installation to assure
proper operation of light will not infringe on other installed components. For all other installations
refer to the dimensional drawing on page 17 of this guide that represents your particular model of light.
The drawings reflect the dimensions of the “working envelope” of a typical light. Endure sufficient
clearances are incorporated in your installation to allow for variations (vehicle body flex, environmental
conditions, future servicing needs, etc.)
Four mounting bolts are required. Additional holes may be drilled in the frame ends if necessary to clear
obstructions.
Access holes for the power cord cabling should be in close proximity to the entrance box on the light.
Installing the cords with a sweeping 90° or 180° bend will provide better results.
The control box holster should be mounted in an area shielded from the weather. Allow a minimum of
10" clearance above the control box holster mounting location for easy access to the controller.
Summary of Contents for SHADOW Series
