Commander Connect Owners Manual
92
To enable/disable Call Logging
Call Logging is disabled by default on power up.
•
From the Programming Station, press the PROGRAM Key
•
Press the Scroll Down Key (
) until ‘System programming’ is displayed
•
Select ‘System programming’
•
Enter the System Programming Password
•
Select ‘System’
•
Press the Scroll Down Key (
) until ‘Call logging’ is displayed
•
Select ‘Call logging’
•
Select either ‘Call logging On', ‘Call logging off’. 'Restricted call log ON', 'Enable Xon /
Xoff' or 'Print Log'.
•
Press the Hands-free Key to finish programming.
To prevent calls from individual Stations being logged
If Call Logging is enabled, then by default all calls from all Stations will be logged. However
individual Stations can be programmed to prevent their calls being logged.
•
From the Programming Station, press the PROGRAM Key
•
Press the Scroll Down Key (
) until ‘System programming’ is displayed
•
Select ‘System programming’
•
Enter the System Programming Password
•
Select ‘Stations’
•
Press the Scroll Down Key (
) until ‘No call logging’ is displayed
•
Select ‘No call logging’
•
Select the Stations whose calls are not to be logged. The selected Stations will be
indicated with a
♦
.
Press the Hands-free Key to finish programming.
To set the call logging interface speed for connecting a Printer or PC
•
From the Programming Station, press the PROGRAM Key
•
Press the Scroll Down Key (
) until ‘System programming’ is displayed
•
Select ‘System programming’
•
Enter the System Programming Password
•
Select ‘System’
•
Press the Scroll Down Key (
) until ‘Set v24 baud rate’ is displayed
•
Select ‘Set v24 baud rate’
•
Select the speed you require – 4800, 9600,19,200, 38,400 or 115,200 bps.
•
Press the Hands-free Key to finish programming.
Note:
To connect a printer or PC for call logging, use the call logging cable provided and
connect one end to the V24 interface on the ME and the other end to the serial device, e.g. a PC
or a printer.
