3
4. Signal and Lamp Specification
*If the situation will occur simultaneously, corridor light and master station lamp
will blink at once.
(Corridor light, shower room, bed, interphone will blink by turns)
5.1 Bed Paging
- Lift up the handset or press the programmed dial button to answer the call.
- Press the Dial Button to Communicate with each Bed.
- While in conversation, Green led lamp will turn on and Call xxxx-Bed no will be
displayed
- Can be communicated with patient in sub station directly
5.2 Sub Station Function
5.2.1 Communication with master station and sub station
- Put the call button in sub station to communicate with master station, and then
green lamp will be lighted and white lamp in corridor will be lighted (in that case,
the Led lamp in master station & alarm is warning)
- Put the cancel switch to cancel the communication in sub station (LED in master
station display as Sub cancel REQ)
5.2.2 Lift up the Handset in Master station for Communication. (Corridor Light will
be off)
5.2.3 If the master station is on line, it will automatically flash the green led on the
bed for its conversation. If press the call button, it will be reserved with the alarming
of red lamp, and then it will be automatically connected after the previous
conversation.
5.3 Room broadcast function
- Put the all paging and group call, each bed is on broadcast, so, it can be use the
Group call with master station.
- In case of using the group call, cannot be use the general call, however,
Emergency switch in toilet, shower room and presence switch is normally operated.
5. How to use and Function
www.safemag.ru
www.safemag.ru
