16
On most mobile telephones it is recommended to authorize Blues to
make the coupling automatically.
Refer to the user’s manual for further details.
Used as neckloop with telephone:
Switch the hearing aid(s) to T or MT.
Switch on Blues by pressing control button (2) for at least one second.
Before establishing contact with the telephone the lamp (1) starts to
flash.Then press the same button again briefly to establish connection
with the mobile phone.
To break the connection with the mobile phone, press button (2) for
about two seconds.
• Making a call
Make a call using the telephone in the normal manner.The sound will be
heard through the neckloop.
To terminate the call, press the control button (2) or hang up the
telephone in the normal manner.The control lamp (1) will give a short
flash and an audible signal will be heard.
An incoming call will be indicated by a ringing tone in the hearing aid.
The control lamp will flash repeatedly while the phone is ringing (phone
dependent). Answer/terminate the call by pressing control button (2).
• Rejecting incoming calls
When the telephone rings and you do not wish to answer the call, hold
button (2) for at least two seconds (gives the busy signal).
• Voice dialling
See the user’s manual of your mobile phone for instructions on
recording names for voice dialling.
Press button (1) briefly; an audible signal will indicate that the unit is
ready for voice dialling. Say the name of the person you wish to call and
the telephone will dial the number automatically.
