7
User manual CIBS Office 1g
NO
EN
NO
EN
8
User manual CIBS Office 1g
NO
EN
NO
EN
Power input
•
24
:
Connection for the accompanied power supply.
In order to receive sound from the Blues II, you need to put your hearing
aid/CI in T or MT position and wear the neck loop around your neck.
Alternatively, you can connect earbuds/headphones to the Blues II.
The functions of CIBS Office
CIBS Office offers a wireless solution for your desk phone.
By connecting Tango VII to your desk phone and wearing
Blues II neck loop, you can enjoy a wireless conversation on the phone,
with a range up to 40 meters. Tango VII also amplifies the sound in the
telephone handset.
Charging of Blues II
Make sure that Blues II is fully charged before using it.
You can charge Blues II the following ways:
Using the charger for wall outlet.
•
Directly from a PC by USB cable (accessory)
•
Using the Twin Charger Cradle (accessory)
•
When charging, the Battery indicator lamp
6
will flash red.
When Blues II is charged, the Battery indicator lamp
6
will illuminate
solid blue.
When the battery is low, the Battery indicator lamp
6
will flash red and
at the same time you will hear a sound signal from the Blues II.
NOTE: The lifetime of the battery will be significantly reduced if
the device is left uncharged for long periods. We advise you to charge the
device at least once a month.
When the operation time of the battery begins to decrease and you wish
to replace it, please send it to your local dealer.
The article number of the battery is: 956-001
Installing the Tango VII
Connect the accompanying power supply to the power socket
24
.
Tango VII will switch itself on automatically. This will be indicated by all
the lights illuminating for some seconds. Tango VII does not have an
on/off switch, but will automatically go into stand-by mode when not in
use.
Volume control for the telephone handset
•
14
a/b:
Press to adjusts the volume of the conversation through the
telephone handset.
Volume indicator for the telephone handset
•
14
c:
Indicates the volume of the conversation through the
telephone handset.
Configuration button
•
14
d:
Press to configure Tango VII, in order to get optimal communication
with your telephone.
Pairing button
•
14
e:
Press to set the Tango VII in pairing mode.
Tone adjustment for the telephone handset
•
15
:
Press to adjusts the tone level of the conversation through the
telephone handset.
Volume control for Blues II
•
16
a/b:
Press to adjusts the volume of the conversation through Blues II.
Volume indicator for Blues II
•
16
c:
Indicates the volume of the conversation through Blues II.
Microphone sensitivity button
•
16
d:
Press to adjust the microphone sensitivity in Tango VII.
Tone adjustment for Blues II
•
17
:
Press to adjusts the tone level of the conversation through Blues II.
Communication light
•
18
Indicates connection between Tango VII and Blues III
Input for the telephone handset
•
19
:
This is where you connect the telephone handset of
your desk phone.
Input for the desk phone
•
20
:
This is where you connect your desk phone with the
accompanied cable.
Input for handset lifter (accessory)
•
21
:
This is where you connect the handset lifter, which enables you to
answer the phone call remotely via your Blues II.
Audio output
•
22
:
This is where you connect e.g. external telecoil amplifier etc.
Dialogue input
•
23
:
Not available on Tango VII
