3 Basic System Operation
CommPact Installation Manual
20
3.6.5. Perimeter
Setting
Perimeter setting is designed for when the occupant intends to remain inside the premises and
secure the perimeter.
To set the system’s perimeter using the front panel keypad or Wireless Keypad:
1.
Check if the system is ready to set.
2.
Press the Perimeter setting key on the keypad.
3.
If One-Key Setting is disabled, enter your user code.
3.6.6. Combination
Setting
The system allows you to activate a combination of two setting methods. If you Perimeter set the
system, you may also activate Full or Part setting. Likewise, you can Perimeter set the system after
activating Full or Part setting. It is not important which setting mode you choose first.
You can activate the second setting mode only during the exit delay of the first setting
mode. When the first exit delay expires, you cannot activate a second setting mode.
For combination setting, perform the following procedure:
1.
Check if the system is ready to set.
2.
Activate the first setting mode.
3.
If One-Key Setting is disabled, enter your user code.
4.
While the exit delay of the first setting mode is counting down, activate the second
setting mode.
5.
If One-Key Setting is disabled, enter your user code.
•
It is not possible to activate Full and Part setting modes simultaneously. It is
necessary to unset first when changing from one setting mode to another setting
mode.
The exit delays of the two setting modes are entirely independent. The moment a setting mode is
activated, its exit delay begins to count down. The entry delay depends on which detector was
tripped first. For example, if the detector is included in Full setting, the entry delay for Full setting
counts down – see p.42,
7.3.2 Set. If the detector is included in both activated setting modes, the
entry delay for Perimeter setting counts down.
Unsetting cancels both active setting modes.
3.6.7. Unsetting
When an entry/exit detector is tripped, the entry delay counts down; each setting method has its
own entry delay.
To unset the system:
•
Enter a valid user code, the system is unset.
You can only unset all the active setting modes.
Summary of Contents for Control system
