10 Communications
CommPact Installation Manual
63
10.1.7. Account Type (Not Relevant for Voice Report)
To program the number of call attempts for an account:
1.
From the Programming menu, select Communications, Accounts [951].
2.
Select the account you want to program (2-6).
3.
From the account’s sub-menu, select Account Type [#7].
4.
Select Primary or Backup.
Account 1 is a primary account.
10.2. Report
Cycles
The system’s attempts to report events are organized in cycles. A report cycle is a set of call
attempts – see p. 62,
10.1.6 Call Attempts (Not Relevant for Voice Report). If the system does not
succeed in sending a report to any of the telephone numbers, it tries to dial the entire report cycle
again until it sends a successful report. You can determine the number of times the system attempts
to dial this sequence by programming the Report Cycle option.
To program the number of Report Cycles:
1.
From the Programming menu, select Communications, Accounts, Report Cycles [9517].
2.
Enter a value between 01 and 15. Press '
√ʹ
.
In the example illustrated in Figure
10-1, Account 1 is programmed with 2 call attempts, Account 2
is programmed with 3 call attempts and the number of report cycles programmed is 3.
Figure 10-1: Typical Report Cycle Sequence
10.3. Vocal Message Dialer
The Vocal Message Dialer is a feature that calls the user’s telephone number when specific events
occur and plays pre-recorded messages. These calls are made after the system has reported the
events to the central station. Additionally, in the event of an alarm, the user is able to establish a
Two-Way Audio connection on receiving the vocal message in order to check the premises.
The system supports up to five Voice Report accounts. Each account has its own telephone number,
communication interface and Two-Way Audio options.
Summary of Contents for Control system
