Appendix B: Transmitter Installation
CommPact Installation Manual
94
Alarm Delay
The Alarm Delay is a feature designed to allow the occupant to move freely within the protected area
without triggering a false alarm. When approaching the protected wall, an alarm is not generated
because the detector’s beams are crossed from the permitted direction. After detecting permitted
motion, the detector counts down the Alarm Delay time. This timer is re-triggered every time the
detector detects motion. During the Alarm Delay, the detector permits motion in both directions. The
duration of the alarm delay is selected using the Alarm Delay Jumper – see Table B-4.
LED Indication
The LED indicator turns red to indicate non-permitted motion and green to indicate motion
detection in either direction. In the event of an alarm, the LED turns red. To disable the LED,
remove the LED Jumper, JP1 located next to the LED indicator – see Table B- 5.
Do not disable the LED until you have successfully walk tested the detector.
PIR Supervision
The circuit operation of the PIR is checked once per hour. In the event of PIR failure the red
LED flashes.
Battery Replacement
Open the housing by removing the front cover (see Installation Instructions), replace the battery, and
close the front cover.
Close the front cover immediately after each battery replacement.
Table B-3: EL-2650XL's
Mode JumperJP3
Table B-4: EL-2650XL's Alarm
Delay Jumper JP
Table B- 5: EL-2650XL's LEDs
Mode
Jumper
JP3
Jumper
Position
Alarm
Delay
Jumper JP2
Jumper
Position
LED Indication
Curtain
Removed
1 minute
Removed
Red
Non-Permitted
motion
Directional
Installed
4 minutes
Installed
Green
Permitted Motion
Signals and Messages:
In case of a low battery (2.5 V and below), the detector low battery condition is reported to the
Control System and low battery message is displayed. When the Back Tamper switch is released,
the detector sends a tamper condition to the Control System that generates tamper alarm.
Wall Mounted
Ceiling mounted
Figure B- 9: Lens Coverage Pattern (Side View)
Summary of Contents for Control system
