860660202 Rev. B
www.commscope.com
Instruction Sheet
© 2021 CommScope, Inc. All Rights Reserved
Page 4 of 9
6.
Powered Fiber Cable (PFC) Termination and Closeout
Step 1 – Route and terminate incoming/indoor Powered Fiber Cable (PFC)
1.
Route the incoming PFC into the TB and secure to the strain relief bar with a supplied cable
tie, as shown in
Figure
4
. Ensure adequate length for fiber slack (1-1.5 meters).
2.
Strip the outer jacket of the PFC using a round cable stripper so that there is approximately
25mm of jacket extending inside the box, as shown in
Figure 5
. Trim any strength members
or other cable components except for power conductors and fibers.
Figure 4 Figure 5
APPROX. 25mm OF
CABLE JACKET
