These four screws
and plastic spacers
are always kept
installed on wind
shield.
13 16 14
7
Passive antenna
1
14
16
13
Pre-bend cable
per cable installation
instruction. Tie the
cable here
17
Fix the wind shield
after jump cables
are installed
Maintenance
wire is to prevent
the wind shield
from falling while
maintaining the
antenna.
Step 5 Mount the antenna assembly on the pole
14 15 16
M12 bolt
18 19 20
M10 bolt
GAP
Step 2 Disassemble the EMPTY BOX
Instruction of replacing wind shield with S4-90M-R1-V2
Step1 Remove the EMPTY BOX assembly from the pole
Step 3 Assemble the antenna and bracket
Step 4 Assemble the antenna and radome
Do not hit the endcap of the passive antenna
during installation. Leave 5 mm gap between
two endcaps.
MAXIMUM TORQUE
M5
4.6N.m (3ft.lbs)
M6
8.0N.m (6ft.lbs)
M10
37N.m (27ft.lbs)
M12
58N.m (43ft.lbs)
639853
Page 3 of 4
www.commscope.com
© 2019 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639853 B (09/19)
