CommScope CMAX-DMF4-43-Wi53 Installation Manual Download

Page: 2 / 5

Installation Instruction for CMAX Antennas

Page 2

M0153A6A_InstInstr_CMAX-DMF4-43-Wi53

2. Wall Mounting

1. Use this pedestal piece as a drill jig to mark 4 holes onto the wall as shown in the drawing

above.

2. Drill 4 holes into the wall and insert 4 expansion bolts into the holes.

Install the mounting kits to the expansion bolts and tighten the M6 nuts and flat

washers.

4. Attach the antenna to the mounting kits and then tighten the M4 nuts, spring washers and

flat washers.

Note:

Cable min. bending radius: 40mm

Summary of Contents for CMAX-DMF4-43-Wi53

Page 1: ...4 43 Wi53 Antenna Note Please read the complete description before starting the installation Make sure that connectors are properly sealed against water if no cables are connected to them after installation 1 Assembly Fit these seven parts above together and fasten them with screws M6 nuts M6 spring washers and washers ...

Page 2: ... holes onto the wall as shown in the drawing above 2 Drill 4 holes into the wall and insert 4 expansion bolts into the holes 3 Install the mounting kits to the expansion bolts and tighten the M6 nuts and flat washers 4 Attach the antenna to the mounting kits and then tighten the M4 nuts spring washers and flat washers Note Cable min bending radius 40mm ...

Page 3: ...Installation Instruction for CMAX Antennas Page 3 M0153A6A_InstInstr_CMAX DMF4 43 Wi53 3 Pole Mounting 28 60 mm pole diameter 4 Antenna Mounting 4 1 Antenna Mounting M6 nut Washer 28 60 mm Spring Washer ...

Page 4: ...letely 2 Adjust your desired angle The complete antenna pedestal can be swiveled to the left right hand side by up to 60 3 Tighten the fixing screws 4 3 Elevation Angle 1 Loosen the fixing screws Do NOT unscrew them completely 2 Adjust your desired angle The complete antenna pedestal can be swiveled to the top bottom by up to 40 3 Fasten the fixing screws ...