Era
™
Medium Power Carrier Access Point Installation Guide
M0201AJB
Page 40
© October 2018 CommScope, Inc.
Installing CAP Ms
3
"Unpack and Inspect the CAP M and Optional Accessories” on page 19
lists the
parts that ship with the CAP M Pole Mounting Kit for Up to 18" Poles.
4
"Determine the Mounting Site” on page 16
to determine the mounting location, which must be
able to support the weight and dimensions of the CAP M.
5
"Mounting Orientation” on page 24
to determine the mounting orientation of the CAP M.
6
Refer to and observe all cautions listed in
"General Mounting Cautions” on page 23
7
Attach either a Single
Mounting Bracket
(CommScope PN
7821955-xx) or a Dual
Mounting Bracket
(CommScope PN
7821954-xx) to the two
screw pins on one of the two
Pole-Mounting Brackets.
Attach the M6 nut and
washers in the order shown.
a
Slide one M6 plain
washer (
7A
) over each
screw pin.
b
Slide one M6 split-lock
washer (
7B
) over each
screw pin, next to the M6
plain washer.
c
Secure one M6 Hexagon
Nut (
7A
) to the end of
each screw pin, and then
torque to 11 N-m.
8
Repeat
on the second Pole-Mounting Bracket.
Table 9.
Parts List for CommScope PN 7692096-XX
Description
Quantity
Description
Quantity
Pole-Mounting Bracket
2
M8 Threaded Bolt
8
Bracket
2
M8 Hexagon Nut
8
M6 Hexagon Nut
4
M8 Plain Washer
16
M6 Plain Washer
4
M8 Split-Lock Washer
8
M6 Split-Lock Washer
4
M8 Nut
8
Installer must verify that the mounting surface will safely support the combined load of the electronic
equipment and all attached hardware and components.
The balance of this procedure may require two installers to complete.
Pole-Mounng
Brackets
Dual-Mounng
Bracket
7c
7a
7b
Screw
pin